Solar and battery care for electronic reel controllers means keeping a small on-board battery charged, clean and protected so the controller can run the reel through the season. This guide links to E110 and E140 solar panel kit pages and an E110 and E140 battery charger page. Check the manual for your exact reel to confirm compatibility and setup, then build a simple routine around the panel, the wiring and the battery.
Key Takeaways
- Use the Kifco manual for your model to confirm battery type, charging and replacement specifications.
- Inspect the solar panel face, cable and battery terminals so a simple fault does not stop the reel.
- Use the linked winterizing guide for the complete seasonal shutdown of the reel.
How Are Electronic Reel Controllers Powered?
Electronic reel controllers are powered by a battery carried on the reel rather than by a power cord. The battery supports the reel's electronic controller. Refer to the manual for your model before diagnosing a display or shutoff problem. See the E110 solar panel kit page and the E140 solar panel kit page, then confirm the correct part and setup in your reel manual.
It helps to think of the system in three parts. Each part can fail on its own, and each one is easy to check.
- The battery. This is the power source. It stores the energy the controller uses.
- The solar kit and its connections. Inspect the panel, cable and connectors, then use the Kifco documentation to identify the charging parts fitted to your reel.
- The wiring and terminals. Loose, corroded or chafed connections stop charge from reaching the battery even when the panel is fine.
Specifications differ between reel models and build years, so the manual and the serial plate are the right sources rather than a general rule of thumb.
How Does a Solar Panel Kit Keep the Battery Charged?
A solar panel kit keeps the battery charged by feeding current into it during daylight, a process often called a solar trickle charge. Daylight reaching the panel is what makes that work, so anything blocking the light or breaking the circuit reduces charging.
Common Reasons a Panel Stops Charging
Start with simple checks when charging seems unreliable. Dust, dried spray residue and bird droppings cut the light reaching the cells. Parking the reel under a tree line or in the shade of a building does the same. A cracked panel face, a pinched cable or a corroded terminal will also starve the battery. Inspect the panel, cable and terminals at the interval given in your reel manual, and follow the panel maker's cleaning instructions.
When Solar Alone Is Not Enough
If the battery needs charging, follow the charging procedure in the manual for your reel. See the E110 and E140 battery charger page, then confirm the right charger for your reel in the manual.
How Should You Store the Battery Over Winter?
Store the battery as the Kifco manual for your model directs, and check it through the off season rather than leaving it until spring. Long-term storage can affect battery condition, so plan the off season work in order.
- Finish the season's shutdown first. Handle the water side before you touch the electrical side.
- Follow the battery removal, storage and charging procedure in the Kifco manual for your model.
- Keep the battery and its terminals clean and dry while it is stored.
- Charge the battery again before the first run in spring.
Inspect and clean the solar panel as directed in your reel manual. For the full machine shutdown, our irrigation reel winterizing and shutdown guide covers the hose, turbine and drive side, so we will not repeat those steps here.
What Are Signs of a Weak Battery?
Signs of a weak battery include a dim or blank display, a controller that resets or loses its settings, a shutoff that fires late or not at all, and a battery that reads fine in the morning but fades by evening. Treat these as possible causes to check, not a finished diagnosis.
Use this table to sort a power fault from a control fault before you pull anything apart.
| What you see | Possible cause | First check |
|---|---|---|
| Display blank or very dim | Battery flat or lead disconnected | Battery voltage and terminal tightness |
| Controller resets during a pull | Voltage sags under load | Battery age and charge state |
| Works in the morning, then quits later in the day | Battery not holding capacity | Charge fully, then retest next day |
| Battery drops after sunny days | Panel or wiring fault | Panel surface, shade, cable and leads |
| Slow or no shutoff at end of pull | Low power or a control fault | Confirm battery first, then the controller |
When Should You Replace the Battery?
Replace the battery when it fails the battery test or replacement criteria in the manual for your reel, or when it is physically damaged. If the fault is unclear, confirm the battery specification and test method before ordering a replacement.
If the battery is visibly damaged or leaking, stop using it and follow the replacement guidance in the manual for your reel. Have unclear battery or terminal problems assessed before ordering a replacement. If the panel appears damaged, check the linked E140 replacement solar panel kit page or the corresponding E110 product page, then confirm the correct part for your reel before ordering.
FAQs
Frequently Asked Questions
Check the manual for your reel before operating it without the solar kit. If the manual allows it, follow the battery charging instructions given there and check battery condition before each run so the controller does not lose power mid pull.
Cloud cover reduces the light reaching the panel, so output falls. Check battery condition before a run when the reel has had limited sunlight or heavy use, and charge it on the charger if the manual's criteria say it is low.
Match the battery type, size and voltage listed in your Kifco manual for your model. A battery with the wrong chemistry or terminal layout may not fit the tray, charge correctly from the solar kit, or power the controller as intended.
Follow the winter battery storage instructions in the Kifco manual for your model, since they cover whether to disconnect. Use the linked winterizing guide for the rest of the reel shutdown so the water side is handled at the same time.
A multimeter can show an obvious low voltage condition after charging and resting the battery. Use the Kifco manual or a qualified battery test to decide whether the battery actually needs replacement, since voltage alone is not a complete test.
A loss of controller power can interrupt electronic functions on the reel. Check the battery and follow the troubleshooting instructions in the manual for your model before operating, so you are not guessing at the cause in the field.
Make Solar and Battery Care for Electronic Reel Controllers a Habit
Solar and battery care for electronic reel controllers starts with checking the panel, wiring and battery before the season. Use your model manual for the correct battery and charging requirements, and replace damaged parts before the first irrigation run rather than during it.
Victory Irrigation sells Kifco reels, pumps and OEM replacement parts. Shop Kifco reel equipment and OEM replacement parts at Victory Irrigation.



